Rod Network Belt

TDA

TDA belts possess a series of characteristics which make the operation of these belts advantageous in a multitude of applications. In general, they are used to transport light weight products at temperatures up to 400ºC.

Made of AISI-304 stainless steel and music wire, they are driven by sprockets over the full width of the belt, which ensure excellent tracking of the belt in a wide variety of load and/or speed situations.

The characteristics are the following:


• Large open-mesh surface area (approximately 80%), which allows the free passage of air, gasses or liquids, and therefore good circulation around the products being conveyed.
• High longitudinal flexibility allowing sprocket, bush and roll diameters of the installation to be small.
• Low weight per square metre.
• Easy to clean and difficult to clog.

TDA belts are made in two selvage finishes; simple or double edge, and in a wide range of wire diameters, module pitches and widths, along with special finishes to meet the client's requirements.
Don't hesitate to contact us for further information regarding the belt type together with the sprockets, spacers and rolls necessary for your installation.

Food industry:

• Coating processes such as chocolate, cream, sugar, etc.

Electronic:

• Transporting components.
• Soldering, varnishing and drying processes of printed circuit boards.

Material handling:

• In-house transport of laminar components such as paper, cloth, plastic, etc.
• Equipment for shrink-wrap packaging.